B15 · The generator effect and Lenz’s law · Notes and practice
Download the printable PDF
Explain how motion in a field separates charge, use ΔV = Blv, and apply Lenz’s law.
Open the complete lesson
Method slides in this lesson: “Method: how to find an induced voltage and its direction”. Worked examples for each question type in B15
After the lesson: Investigate and connect (a short investigation, a data step and a real-world link)
Type in the blanks; your notes save on this device only. Nothing is submitted.
Slide 1 of 8 · A moving rod separates charge
Key ideas
The generator effect runs the motor effect backward: . Pulling a rod through a field pulls its through the field too. Each feels a force.
Right hand: fingers along the , thumb along the rod’s (in B14 the thumb pointed along the current). The palm shows the force on a charge. it for electrons.
The electrons gather at one end, so that end is . The other end is .
Reverse the velocity or the field, and the polarity .
Example
A horizontal metal rod is pulled straight down the page through a magnetic field that points into the page. Which end of the rod, left or right, becomes positive?
Try it
A vertical rod is pulled to the right through a magnetic field that points out of the page. Which end, top or bottom, becomes positive, and how does this compare with the field into the page?
Slide 2 of 8 · How large is the potential difference?
Key ideas
ΔV is the potential difference between the of the rod. ΔV = . B is the field (T), l is the rod length (m), v is the speed (m/s).
Faster rod, longer rod or stronger field: a ΔV. 1 T × 1 m × 1 m/s = . Example: (0.250 T)(0.40 m)(3.0 m/s) = .
The equation is on the data sheet. Write the rearranged form, such as v = , before the numbers.
For ratio questions, the change factors. Never add them.
Example
A rod of length 0.60 m moves at right angles to a magnetic field of 0.150 T and to its own length. The potential difference between its ends is 0.90 V. What is the speed of the rod? (ΔV = Blv)
Try it
A rod moving through a field produces a potential difference ΔV. A second rod has twice the length, moves at half the speed, and is in a field three times as strong. What is its potential difference? A. ΔV/3 B. ΔV C. 3ΔV D. 6ΔV
Slide 3 of 8 · Closing the circuit
Key ideas
The rod slides on two (parallel metal bars) with a (a part that uses electrical energy, like a lamp) joining the ends. The rod acts like a .
Conventional current leaves the end, goes round the circuit and returns to the end. Inside the rod it goes from negative to positive.
Find the ends first (right hand, then reverse). Then the current: clockwise or counterclockwise.
Reverse the velocity or the field, and the current .
Example
A rod slides on two rails. A resistor joins the right-hand ends of the rails, and the magnetic field points into the page. When the rod is pulled to the right the top end is positive and the current is clockwise. Now the rod is pulled to the left. Does conventional current go clockwise or counterclockwise?
Try it
Same rails and rod, but the field now points out of the page and the rod is pulled to the right. Does conventional current go clockwise or counterclockwise, and which end of the rod is positive?
Slide 4 of 8 · A magnet and a coil
Key ideas
A coil can do it too. When a magnet and a coil move to each other, the electrons in the coil feel a force. This is electromagnetic . Michael discovered it in 1831.
Current flows only they move. A magnet held still gives current.
Reverse the motion or the pole, and the current .
Faster, a stronger magnet or more turns gives current. Four times the turns gives about the current.
Example
Pushing the south pole of a bar magnet into a coil at a steady speed deflects the meter needle to the right. Predict the needle for (a) pulling the same pole out at the same speed, (b) pushing the north pole in at the same speed, (c) pushing the south pole in twice as fast, and (d) holding the magnet still inside the coil.
Try it
Pushing the south pole into a coil at a steady speed gives a deflection of 2 divisions to the right. Predict the needle if the same pole is pushed in at half the speed into a coil with four times as many turns.
Slide 5 of 8 · Motors and generators
Key ideas
A motor and a generator are the same device used both ways. Motor: electricity in, out. Generator: motion in, out.
Name the energy change: motion to , or the reverse.
A generator joined to a lamp is to turn. Its current is in a field, so it feels a force that the turning.
With nothing connected there is no , so no force. The extra you do goes into the lamp’s energy.
Example
A hand-cranked generator is easy to turn when its wires are not connected to anything, and noticeably harder when it is connected to a lamp that lights. Explain why it is harder when connected, and where the extra energy goes.
Try it
A small toy motor is spun by hand with its two wires joined to a lamp, and the lamp lights. Is the device acting as a motor or a generator? Name the energy change.
Slide 6 of 8 · Lenz’s law: the force opposes the motion
Key ideas
A moving magnet makes currents in a conductor. A current made by motion in a field, with no battery, is an current. It feels a , and the force acts on the magnet.
Lenz’s law: the force from an induced current the motion that caused it. A magnet falling feels a force .
Chain: motion → → → slower fall. No current means force. A better conductor carries a current.
The force always opposes the motion. It takes energy .
In air the magnet falls 0.30 m in . In the aluminium tube it takes .
Example
Three rods of the same size, one plastic, one aluminium and one copper, each have a ring magnet dropped over them from the same height. Copper conducts better than aluminium; plastic is an insulator. Order the rods from fastest fall to slowest and explain.
Try it
A pendulum with a strong magnet at its end swings between two aluminium blocks and is moving to the right through its lowest point. What is the direction of the magnetic force on the magnet right now, what happens to the swing over time, and does this force’s direction change when it swings back to the left?
Slide 7 of 8 · Lenz’s law for a coil: which way the current goes
Key ideas
An induced current turns a coil into a . By Lenz’s law, that magnet the motion that caused the current.
Step 1: which way is the magnet ? Step 2: which pole opposes that? A magnet moving closer must be , so the near end is the pole. A magnet moving away must be , so the near end is the pole.
Step 3: the field inside a coil points toward its end. Grip a wire on the of the coil with the right hand, thumb along the conventional current. The fingers inside the coil show the field.
Thumb up puts the field inside to the . Thumb down puts it to the . Reverse the motion and the pole and the current both .
Example
A coil is joined to a meter in a closed circuit. The north pole of a bar magnet is pushed toward the right end of the coil. (a) Which pole does the right end of the coil become? (b) Which way does the conventional current go in the wires on the front of the coil, up or down? (c) The magnet is then pulled back out. What happens to the pole and to the current?
Try it
NEW, for teacher review: The south pole of a bar magnet is pushed toward the left end of a coil in a closed circuit. Which pole does the left end of the coil become, and which way does the conventional current go in the wires on the front of the coil?
Slide 8 of 8 · Method: how to find an induced voltage and its direction
Key ideas
Step 1: list v, B and l with units: , , . All at .
Step 2: ΔV = . Keep every digit. The unit is .
Step 3: right hand, then reverse for electrons. They gather at the end. The other end is .
Step 4: current leaves the end. Step 5: : the force on the rod v. Reverse v or B, and every direction .
Example
A 0.40 m rod is pulled to the right at 3.0 m/s through a field of 0.250 T that points into the page. The rod is part of a closed circuit with a resistor on the right. Find the potential difference, the positive end, the direction of the current and the direction of the force on the rod.
Try it
A 0.60 m rod is pulled to the left at 2.0 m/s through a field of 0.500 T that points into the page. The rod is part of a closed circuit with a resistor on the right. Find the potential difference, the positive end, the direction of the current and the direction of the force on the rod. Write each step number beside your work.
Answer the practice problems online · Completed notes and worked key
B15-N01
B15-N01. What is the difference between the motor effect and the generator effect?
Response: ____________________
B15-N02
B15-N02. A vertical rod is pulled to the right through a magnetic field that points into the page. Which end of the rod becomes positive?
- The top end
- The bottom end
- The left end
- Neither end
Response: ____________________
B15-N03
B15-N03. A 0.80 m rod moves at 5.0 m/s at right angles to a field of 0.040 T and to its own length. Find the potential difference between its ends.
Response: ____________________
B15-N04
B15-N04. A 0.50 m rod moves at 12 m/s at right angles to a 0.25 T field. What potential difference appears between its ends?
Response: ____________________
B15-N05
B15-N05. A magnet is pushed into a coil and the meter shows a current. List three changes that would make the current larger.
Response: ____________________
B15-N06
B15-N06. Why is a generator harder to turn when it is connected to a lamp?
- The induced current gives a magnetic force that opposes the motion.
- The lamp makes the magnet heavier.
- The lamp removes the magnetic field.
- The coil stops being a conductor.
Response: ____________________
B15-N07
B15-N07. A magnet is dropped from rest through 0.30 m in air. Find the free-fall time. Then compare it with 2–3 s for the same magnet inside a vertical aluminium tube. Use g = 9.81 m/s². Give the free-fall time in seconds.
Response: ____________________
B15-N08
B15-N08. A magnet is dropped through a plastic tube, an aluminium tube and a copper tube of the same size. Rank the fall times from shortest to longest and explain.
Response: ____________________