B15 · The generator effect and Lenz’s law · Extra practice
Download the printable PDF · Answer online · Notes and practice
B15-X01
B15-X01. A metal rod 0.500 m long moves at 4.0 m/s at right angles to a magnetic field of 0.300 T. Find the potential difference across its ends, in volts.
Response: ____________________
B15-X02
B15-X02. A rod 0.300 m long moves through a field of 0.150 T at right angles. The potential difference across it is 0.45 V. Find the speed of the rod, in m/s.
Response: ____________________
B15-X03
B15-X03. The north pole of a bar magnet is pushed toward a coil that is part of a closed circuit. Which statement is correct?
- The induced current makes a field that pulls the magnet in faster.
- No current is induced, because the magnet is not touching the coil.
- The current flows only after the magnet stops.
- The induced current makes a field that opposes the motion, pushing the magnet away.
Response: ____________________
B15-X04
B15-X04. A rod 0.400 m long moves at right angles to a field of 0.500 T. At 3.0 m/s the potential difference across it is 0.600 V. Find the speed that gives a potential difference of 1.5 V.
Response: ____________________
B15-X05
B15-X05. A rod moves to the right through a magnetic field that points into the page. Which end of the rod becomes positive?
- The bottom end
- The top end
- The right end, in front of the motion
- Neither end; the rod stays neutral
Response: ____________________
B15-X06
B15-X06. A wire of length 1.20 m moves at 15 m/s at right angles to a field of 75 mT. Convert the field to tesla first. Find the potential difference across the wire, in volts.
Response: ____________________
B15-X07
B15-X07. The north pole of a bar magnet is released above a closed copper ring and falls toward it. Which statement describes the force of the ring on the magnet?
- It points downward, helping the fall.
- It is zero, because copper is not magnetic.
- It points sideways.
- It points upward, opposing the fall.
Response: ____________________
B15-X08
B15-X08. A rod slides on two rails. Explain why a current flows only when the rails are joined by a circuit, and why pulling the rod gets harder when the circuit is closed.
Response: ____________________