B14 · The motor effect · Notes and practice
Download the printable PDF
Find the direction and size of the magnetic force on a current-carrying wire, F = ILB.
Open the complete lesson
Method slides in this lesson: “Method: how to choose the tool for a wire in a field”. Worked examples for each question type in B14
After the lesson: Investigate and connect (a short investigation, a data step and a real-world link)
Type in the blanks; your notes save on this device only. Nothing is submitted.
Slide 1 of 7 · Why a wire in a field is pushed
Key ideas
A wire carries a huge number of moving charges, all moving the way, so each feels the force in the same direction and the whole wire is pushed. This is the motor effect: .
Conventional current is the way charge would move, so it points to the electron flow. Every hand rule in this course uses conventional current.
Right-hand rule for a wire (the same rule as for one charge in B11): fingers along the , thumb along the , shows the force. For electron flow, point the thumb along the and the force comes out of the .
Example: fingers into the page, thumb right, palm faces , so the force on the wire is up the page. Reversing the field or the current flips the force; reversing both flips it .
Example
A wire carries conventional current from left to right through a magnetic field that points out of the page. In which direction is the magnetic force on the wire?
Try it
A vertical wire in the plane of the page carries electrons moving down the page. The magnetic field points to the right across the page. Which way is the force on the wire: into the page, out of the page, left or right?
Slide 2 of 7 · The size of the force: F = I L B
Key ideas
More current, more length in the field and a stronger field each give more force. They multiply: F = , where L⊥ is the length . Only the length counts.
Current is charge per time: I = , in amperes, where one ampere is . Units: 1 T = , so A × m × T gives .
θ is the angle between the and the , and L⊥ = . As for velocity in B11, only the part across the field counts. At 90°, L⊥ = .
Numerical questions often hide a step, such as finding I from . Check that the angle is measured from the , then decide sine or cosine. A picture settles it.
Example
18 C of charge pass a point in a wire in 4.0 s. A 0.120 m length of the wire lies at right angles to a uniform magnetic field of 0.450 T. What is the current, and what is the size of the magnetic force on the wire?
Try it
A straight wire of length 0.20 m carries 6.0 A through a magnetic field of 0.500 T, at 30° to the field direction. What is the size of the magnetic force on the wire?
Slide 3 of 7 · Magnetic force against gravity
Key ideas
A wire in a field can feel the magnetic force and gravity at once. Gravity is downward; convert the mass from to kilograms. g = 9.81 , the same as 9.81 m/s².
If the two forces point opposite ways, the sizes; the net force points the way of the larger force.
A wire that hangs still has net force , so ILB = and I = . “Suspended” and “hangs motionless” both mean net force zero. Size check: a weaker field needs a current.
Equal in size and opposite in direction is not the same as equal as . A stationary wire can still have forces on it; they just .
Example
A horizontal wire of mass 1.40 g has 0.0900 m of its length in a horizontal magnetic field of 0.0500 T. The north pole is on the left, the south pole on the right, and the current is 4.00 A toward you. What are the magnetic force, the weight, and the net force on the wire?
Try it
The same wire (1.40 g, 0.0900 m in a 0.0500 T field) hangs still between the magnets with the current toward you. What current is needed to suspend it? Use g = 9.81 N/kg.
Slide 4 of 7 · Method: how to choose the tool for a wire in a field
Key ideas
Step 1: write what is and every . Note if the wire is at .
Step 2: a current in a wire uses F = . One moving charge uses F = , from lesson B11.
Step 3: use only the length , and L sin θ if the wire is . Change grams to .
Step 4: right hand: fingers along the , thumb along current, palm shows the . Electron flow? it first.
Step 5: gravity pulls with mg. A wire at rest has Fnet = , so ILB = . Otherwise subtract the smaller force from the larger.
Check: units A·m·T give . Do the two forces point ways? On the diploma: a wire at rest is , not “without force”.
Example
A horizontal wire of mass 1.40 g hangs still between a north pole on the left and a south pole on the right. 0.0900 m of its length is in the field, the field is 0.0500 T and the current is toward you. What current holds the wire still, and which way is the magnetic force?
Try it
NEW, for teacher review. A horizontal wire of mass 2.40 g has 0.150 m of its length in a horizontal field of 0.0800 T. The north pole is on the right, the south pole is on the left and the current is away from you. The wire hangs still. What is the current, and is the magnetic force up or down?
Slide 5 of 7 · Reading a force graph
Key ideas
A wire rests on a balance and carries a current in a magnet’s field, so the magnetic force pushes . The balance reads F = . Plot F against I and match it to y = (slope)x + (intercept), as in B5.
The slope is and the vertical intercept is , the force of gravity when the current is zero. The line does not start at zero because gravity always pulls .
From the line: B = and m = . Use kilograms for mass and tesla for field.
Pick two points , not data points. Show the slope and intercept steps with . To predict a reading use the equation of the line, because ILB alone leaves out the weight.
Example
A balance reading F against current I gives a straight line through P (0.80 A, 0.530 N) and Q (4.00 A, 0.786 N). The length of wire in the field is 0.120 m. Find the field strength B and the mass of the wire and supports.
Try it
Using the same line, F = (0.0800 N/A)I + 0.466 N, predict the balance reading when the current is 2.50 A.
Slide 6 of 7 · Two wires, two forces
Key ideas
Each wire makes a field, and each sits in the other’s field. Do two steps: find the of one wire at the other, then the on the second wire.
Rule 1 (the field of a wire): grip with your right hand, along the current; the fingers curl the way the field goes. For current up, the field on the right side of the wire is the page.
Rule 2 (the force on a wire): fingers along the , thumb along the , shows the force.
Currents in the direction attract; currents in directions repel. The two forces are equal in size and opposite in .
Use the same-direction rule as a on your answer. A slinky with current shrinks because neighbouring turns .
Example
Wire A carries conventional current up the page. Wire B, to its right, carries conventional current down the page. Do the wires attract or repel, and which way is the force on B?
Try it
Wire A carries conventional current down the page. Wire B, to its right, also carries conventional current down the page. Which way is the force on B, and do the wires attract or repel?
Slide 7 of 7 · How a motor’s coil turns
Key ideas
A motor is a of wire in a magnetic field. Each side of the loop is a wire in a field, so use the same rule: fingers along the , thumb along the , palm shows the force.
The two sides carry current in directions, so the forces on them are . One side is pushed into the page and the other out of the page, so the loop .
The top and bottom sides run the field, so they feel force.
After half a turn the sides swap places. The (a split ring) reverses the every half turn, so the loop keeps turning the way.
More or more of wire gives a larger force. Reverse the current, or the field, and the motor turns the way.
Example
A rectangular loop sits between a north pole on the left and a south pole on the right, so the field points to the right. Conventional current goes down the left side of the loop and up the right side. (a) Which way is the force on the left side, and on the right side? (b) Does the loop turn the same way as it does with current up the left side, or the opposite way?
Try it
NEW, for teacher review: The same loop has conventional current up its left side and down its right side. The magnets are swapped, so the field now points to the left. Which way is the force on the left side, and on the right side?
Answer the practice problems online · Completed notes and worked key
B14-N01
B14-N01. A wire carries conventional current to the right through a magnetic field that points up the page. The magnetic force on the wire is
- into the page
- out of the page
- up the page
- to the right
Response: ____________________
B14-N02
B14-N02. A 0.250 m length of wire carries 5.0 A at right angles to a magnetic field of 0.80 T. Find the magnetic force on the wire.
Response: ____________________
B14-N03
B14-N03. 12 C of charge pass through a wire in 3.0 s. A 0.100 m length of the wire is at right angles to a field of 0.50 T. Find the magnetic force on that length.
Response: ____________________
B14-N04
B14-N04. A wire of mass 2.4 g has 0.100 m of its length at right angles to a field of 0.250 T. What current makes the magnetic force exactly balance gravity? Use g = 9.81 m/s².
Response: ____________________
B14-N05
B14-N05. A wire of mass 1.40 g has 0.0900 m of its length in a field of 0.0500 T. A current of 4.00 A flows so that the magnetic force points down. Find the size of the net force on the wire.
Response: ____________________
B14-N06
B14-N06. A graph of scale reading against current for a wire in a field gives the line F = 0.0800 I + 0.466 (F in newtons, I in amperes). What should the scale read at 5.5 A?
Response: ____________________
B14-N07
B14-N07. Two parallel wires carry currents in the same direction. Do they attract or repel? Explain using the field of one wire and the force on the other.
Response: ____________________
B14-N08
B14-N08. A horizontal wire of mass 5.00 g has 0.200 m of its length in a horizontal field of 0.150 T at right angles to the wire. What current holds the wire up, and what direction must the force have? Give the current in A. Use g = 9.81 m/s².
Response: ____________________