B15 · Investigation: analyze and explain · Notes

Download the printable PDF

Goals: Set out results in a table and compare them with predictions. Explain a difference with a possible cause and a test. Write a conclusion with a claim, evidence and an explanation.

Type in the blanks. Your notes save on this device only. Use the backup buttons at the bottom to keep a copy. Nothing is submitted.

Slide 1 of 7 · Put the evidence in a table

Key ideas

This is a sample data set. It was not measured by us. A table puts the evidence in , with one row for each cell.

The columns are the metal, the predicted voltage, the measured voltage and the . The predicted values are calculated from the .

The measured values are , because they came from a voltmeter. A reader must be able to tell which numbers were seen and which were .

A good table has a , units in the headings (V) and a note of the controlled conditions, such as solutions.

Example

A given sample set gives four metals joined to copper at 1.0 mol/L. Zinc is 1.10 V predicted and 1.07 V measured, iron 0.79 V and 0.76 V, nickel 0.60 V and 0.57 V, silver 0.46 V and 0.43 V. Organize it in a table.

Try it

Another given sample set has a zinc and silver cell with 1.56 V predicted and 1.52 V measured. An iron and silver cell has 1.25 V predicted and 1.21 V measured. Organize it in a table with a title and units.

Slide 2 of 7 · Compare prediction and observation

Key ideas

Difference = . For zinc, 1.10 − 1.07 = V, and the other three cells also give 0.03 V.

Every measured voltage is than its prediction by the same 0.03 V. A constant gap means something small affects all the cells in the .

The order of the voltages also matches: zinc is highest and is lowest. So the data the prediction. We say support, not prove.

It is called the percent difference, or percent error: (predicted − measured) ÷ × 100. For zinc, 0.03 ÷ 1.10 × 100 = 2.7 %, which is with one significant digit.

Example

Given given predicted and measured voltages: zinc 1.10 V and 1.07 V, iron 0.79 V and 0.76 V, nickel 0.60 V and 0.57 V, silver 0.46 V and 0.43 V. Find each difference and describe the pattern. Then find the percent difference for zinc.

Try it

A given iron and silver cell has a predicted voltage of 1.25 V and a measured voltage of 1.21 V. Find the difference and the percent difference. Is the measured value higher or lower?

Slide 3 of 7 · Explain the difference

Key ideas

Possible causes of a constant gap: the salt bridge adds , metal strips can carry a thin coating, and the solutions may not be exactly 1.0 mol/L.

Each cause is only , because we have not tested it. Do not claim a cause that was .

To test a cause, change and measure again. If we sand the strips and the voltage rises toward the prediction, the oxide was part of the cause.

Temperature also affects voltage. Table values assume 1.0 mol/L solutions, and 101.325 kPa for gases. A good report records the and the concentration.

Example

Every given measured voltage was 0.03 V lower than the table value. Give two possible causes. Describe one test for one of them.

Try it

A student suspects the solutions were not exactly 1.0 mol/L. Describe a test. Say what to change, what to measure and what result would support the cause.

Slide 4 of 7 · Method: how to analyze and explain results

Key ideas

Step 1. a table with a title, units and predicted and measured columns.

Step 2. Compare prediction and observation. Percent difference = (predicted − measured) ÷ × 100.

Step 3. Explain a gap with one cause and say how you would test it.

Step 4. Separate the from the inference. An observation is seen or measured.

Step 5. Write a that answers the question, with claim, evidence and reason.

Step 6. Name a limitation and an , such as repeating trials and averaging.

Example

Use the method on these given results. Zn: predicted 1.10 V, measured 1.07 V. Fe: 0.79 and 0.76. Ni: 0.60 and 0.57. Ag: 0.46 and 0.43.

Try it

Use the method on one given result: nickel and copper, predicted 0.60 V, measured 0.57 V. Find the difference and write a claim.

Slide 5 of 7 · Identify products from observations

Key ideas

In the zinc and copper cell, the zinc strip loses mass, so zinc is : Zn → Zn²⁺ + 2e⁻.

The copper strip gains a coating, so copper ions are reduced: Cu²⁺ + 2e⁻ → . The blue colour of the solution .

An is what we see or measure, such as a mass change, a coating or a colour. An is a conclusion drawn from observations.

Zinc ions are colourless, so Zn²⁺ is , not seen. Together the evidence supports Zn + Cu²⁺ → .

Example

In a zinc and copper cell, the zinc strip gets thinner. The copper strip gets thicker with a reddish-brown coating. The blue solution fades. Name the products. Sort the statements into observations and inferences.

Try it

An iron nail is placed in blue copper(II) sulfate solution. The nail gets a reddish-brown coating and the blue colour fades. Name one observation and one inference. Write the cell reaction.

Slide 6 of 7 · Your turn: judge the nickel and copper result

Key ideas

A conclusion has three parts: the , the evidence and a possible for the gap.

Compare the voltages. Supplied: predicted 0.60 V and measured 0.57 V, a difference of V. The nickel strip lost mass and the copper strip gained a coating, which fits a nickel .

The reaction is Ni + Cu²⁺ → . Salt bridge resistance or oxide on the nickel could lower the voltage, but we write this as because it was not tested.

A is a weakness in how the data were collected. One trial does not show the variation. Repeat trials and average, and clean the strips.

Example

Given a given nickel and copper result: predicted 0.60 V and measured 0.57 V. The nickel strip lost mass and the copper strip gained a coating. Write a conclusion with a claim, evidence and a possible explanation. Add one limitation and one improvement.

Try it

Given a given iron and copper result: predicted 0.79 V and measured 0.76 V. The iron strip lost mass and the copper strip gained a coating. Write a claim, the evidence, the reaction and one improvement.

Slide 7 of 7 · Evaluate a battery design

Key ideas

Cells in a row add voltages. To find the battery voltage, multiply one cell by the . Three cells at the given 1.07 V give 3 × 1.07 = .

Voltage is only one part of the evidence. We also judge mass, cost, , the risk of , and safety and disposal.

Used batteries contain metals such as zinc, lead or cadmium that harm soil and water, so they are collected for . A rechargeable cell makes less , but recycling costs energy.

A fair fuel cell presentation states the purpose, the half-reactions, the and the . A hydrogen fuel cell gives about per cell.

Example

A team builds a battery from three zinc and copper cells in a row. The given measured voltage of one cell is 1.07 V. Find the battery voltage. Name two other things to judge, and say what should happen to the used battery.

Try it

A battery has five cells in a row, each with a given measured voltage of 1.07 V. Find the battery voltage. Give one benefit and one issue of recycling the used battery.

Practice 1

Given a result for an iron and copper cell: predicted 0.79 V, measured 0.74 V. Find the difference. The order of the voltages matches the table. Does the result support the prediction?

Practice 2

Name three things a good table of results includes.

Practice 3

Every measured voltage is lower than the predicted one. Give two possible causes. Describe a test for one of them.

Practice 4

A copper strip is put in silver nitrate solution. It gains a grey coating and the solution turns blue. Name the observations and give one inference.

Practice 5

In one trial, a measured voltage is 0.10 V lower than predicted. Give one limitation of the investigation and one improvement.

Practice 6

A battery has four cells in a row. Each cell measures 1.07 V. Find the battery voltage. Name one thing to do with the used battery.

Practice 7

Challenge: Given results for three cells. Zn / Cu: predicted 1.10 V, measured 1.04 V. Fe / Cu: predicted 0.79 V, measured 0.73 V. Zn / Fe: predicted 0.31 V, measured 0.25 V. Find the difference for each cell. Describe the pattern. Then give the most likely cause and one test for it.