B10 · Faraday's law · Notes

Download the printable PDF

Goals: Find the charge from current and time, with the time in seconds. Use the Faraday constant and a half-reaction to find moles of metal. Find the mass deposited, or the time needed, in an electrolysis.

Type in the blanks. Your notes save on this device only. Use the backup buttons at the bottom to keep a copy. Nothing is submitted.

Slide 1 of 8 · Current is charge per second

Key ideas

Electric charge is measured in , C. Current, I, is the charge that passes a point every .

Current is measured in , A. One ampere means each second.

Charge equals current times time: q = . Here q is the charge in coulombs, I is the current in amperes and t is the time in .

If the time is in minutes or hours, change it to seconds first. 1 min = s and 1 h = s.

Example

A current of 4.00 A runs through an electrolytic cell for 5.00 minutes. How much charge moves, in coulombs?

Try it

A current of 2.50 A runs through an electrolytic cell for 12.0 minutes. How much charge moves, in coulombs?

Slide 2 of 8 · Charge to moles of electrons

Key ideas

One mole of electrons carries . This is the , F, printed in the Data Booklet on p. 3.

F = 9.65 × 10⁴ C/mol e⁻. The unit says coulombs for of electrons.

To change coulombs to moles of electrons, by F: n(e⁻) = . Here n(e⁻) is the moles of electrons and q is the charge.

Coulombs divided by coulombs per mole leaves . A small charge should give a number of moles.

Example

A charge of 1500 C moves through a cell. How many moles of electrons is that? Use F = 9.65 × 10⁴ C/mol e⁻.

Try it

A charge of 4.80 × 10³ C moves through a cell. How many moles of electrons is that? Use F = 9.65 × 10⁴ C/mol e⁻.

Slide 3 of 8 · Electrons to moles of metal

Key ideas

The coefficient of e⁻ in the reduction half-reaction gives the mole ratio. In Cu²⁺ + 2e⁻ → Cu, mol of electrons make mol of copper.

So n(Cu) = n(e⁻) . Here n(Cu) is the moles of copper.

For silver, Ag⁺ + e⁻ → Ag, the ratio is . For aluminium, Al³⁺ + 3e⁻ → Al, divide by .

The ratio is set by the . Write the half-reaction every time and never guess the ratio.

Example

A cell supplies 0.0155 mol of electrons to the cathode, where Cu²⁺ + 2e⁻ → Cu. How many moles of copper form?

Try it

A cell supplies 0.0450 mol of electrons to the cathode, where Al³⁺ + 3e⁻ → Al. How many moles of aluminium form?

Slide 4 of 8 · The full chain to a mass

Key ideas

The Faraday chain is: current and time give , charge gives , the half-reaction gives moles of metal, and molar mass gives mass.

First change the time to seconds and find q = It. Then n(e⁻) = . Then divide by the to find n(metal).

Finally m = . Here n is the moles of metal and M is the molar mass in , from the periodic table.

The chain as one formula is m = (I × t × M) ÷ (z × F). Here z is the in the half-reaction, and t is in .

Example

Zinc is plated from Zn²⁺ solution by a current of 2.50 A for 25.0 minutes. What mass of zinc forms at the cathode? M(Zn) = 65.41 g/mol.

Try it

Copper is plated from Cu²⁺ solution by a current of 3.00 A for 30.0 minutes. What mass of copper forms at the cathode? M(Cu) = 63.55 g/mol.

Slide 5 of 8 · Method: how to find a mass from current and time

Key ideas

Step 1. Change the time to . Multiply minutes by 60.

Step 2. Find the charge: q = .

Step 3. Find the moles of electrons: n(e⁻) = q ÷ , with F = 9.65 × 10⁴ C/mol e⁻.

Step 4. Use the ratio to find the moles of the substance.

Step 5. Find the mass: m = .

Step 6. Round , at the end, to three significant digits.

Example

Use the method on 2.50 A for 25.0 minutes plating zinc from Zn²⁺ solution. Find the mass of zinc.

Try it

Use the method on 1.50 A for 20.0 minutes plating silver from Ag⁺ solution. M(Ag) = 107.87 g/mol. Find the mass of silver.

Slide 6 of 8 · Your turn: silver

Key ideas

Hours must be changed to seconds in two steps: 1.00 h = min = s.

Charge: q = It = 0.500 A × 3600 s = . Then n(e⁻) = q ÷ F = mol.

In Ag⁺ + e⁻ → Ag the ratio is , so n(Ag) = n(e⁻). Show this step even when the ratio is 1 to 1.

Finally m = n × M = 0.01865 mol × . Check that the units give grams: mol × g/mol leaves .

Example

A silver nitrate solution carries 0.500 A for 1.00 hour. The half-reaction is Ag⁺ + e⁻ → Ag. What mass of silver forms at the cathode? M(Ag) = 107.87 g/mol.

Try it

A copper(II) sulfate solution carries 0.750 A for 45.0 minutes. The half-reaction is Cu²⁺ + 2e⁻ → Cu. What mass of copper forms at the cathode? M(Cu) = 63.55 g/mol.

Slide 7 of 8 · Running the chain backward

Key ideas

To run the chain backward, start at the given and find moles with n = . Here m is the mass in grams and M is the molar mass.

Go from metal to electrons by by the coefficient of e⁻. For Al³⁺ + 3e⁻ → Al, n(e⁻) = × n(Al).

Change moles of electrons to charge by multiplying by . Then find the time with t = .

Coulombs divided by amperes leaves . Divide by for minutes if the question asks for minutes.

Example

We want 1.00 g of aluminium from Al³⁺ using a steady current of 5.00 A. How long must the current run, in seconds and in minutes? M(Al) = 26.98 g/mol.

Try it

We want 1.50 g of zinc from Zn²⁺ using a steady current of 3.00 A. How long must the current run, in minutes? M(Zn) = 65.41 g/mol.

Slide 8 of 8 · What the calculation assumes

Key ideas

The calculation assumes the charge makes the wanted metal. In real cells some charge goes to , so a little less metal forms.

Mass deposited is the mass the cathode : the final mass the starting mass.

The same chain also works in a cell. The electrons in the wire come from the half-reaction.

In a zinc and copper cell, Zn → Zn²⁺ + and Cu²⁺ + 2e⁻ → . The same electrons do both jobs.

Example

A cathode has a mass of 31.40 g before plating and 32.15 g after plating. What is the mass deposited? What does the calculation assume about the charge?

Try it

In a zinc and copper voltaic cell, 0.0200 mol of electrons pass through the wire. How many moles of zinc are oxidized at the anode, and how many moles of copper deposit on the cathode?

Practice 1

Given a current of 4.00 A for 30.0 minutes. Find the charge that moves, in coulombs.

Practice 2

Given a charge of 7.20 × 10³ C. Find the moles of electrons, using F = 9.65 × 10⁴ C/mol e⁻.

Practice 3

Given 0.0746 mol of electrons and the half-reaction Cu²⁺ + 2e⁻ → Cu. Find the moles of copper formed and the mass (M = 63.55 g/mol).

Practice 4

Given 2.00 A for 45.0 minutes and the half-reaction Zn²⁺ + 2e⁻ → Zn (M = 65.41 g/mol). Find the mass of zinc deposited.

Practice 5

Given 1.50 A for 2.00 hours and Ag⁺ + e⁻ → Ag (M = 107.87 g/mol). Find the mass of silver deposited.

Practice 6

Given that 2.00 g of copper must form from Cu²⁺ at a steady 2.50 A (M = 63.55 g/mol). Find the time needed in minutes.

Practice 7

Challenge: Given two electrolytic cells joined in a row, so the same current passes through both. One cell plates silver (Ag⁺ + e⁻ → Ag, M = 107.87 g/mol). The other plates copper (Cu²⁺ + 2e⁻ → Cu, M = 63.55 g/mol). The current is 1.25 A for 20.0 minutes. Find the mass of each metal deposited, in grams. Use F = 9.65 × 10⁴ C/mol e⁻.