A12: Investigate and connect

Predicting boiling points and solubility. Do this after the lesson. It takes about 20 minutes.

Outcomes practised: 20-A2.1s, 20-A2.2s, 20-A2.3s, 20-A2.4s, 20-A2.2sts

You need: Graph paper, a ruler and a pencil.

A noble gas is made of single atoms. The only force between them is the London force. How does the boiling point of a noble gas depend on its number of electrons?

1. Plan

  1. Hypothesis. Write one sentence with "if", "then" and "because". Use what you know about London forces.
  2. Predict. Sketch the shape you expect the graph to have.
  3. Plan the graph. Put the number of electrons on the horizontal axis. Put the boiling point on the vertical axis.
  4. Choose scales. The boiling points are all below zero. Make sure every value fits.
  5. Plot the five points from the table. Draw a smooth curve through them.

2. The results

These results are examples for this lesson. Your class did not measure them.

Supplied boiling points of five noble gases
Noble gasElectronsBoiling point (°C)
He2−268.9
Ne10−246.1
Ar18−185.8
Kr36−153.2
Xe54−108.1

3. Work with the results

  1. Describe the pattern in your graph.
    Compare after your attempt

    The boiling point rises as the number of electrons rises. The curve goes up from left to right.

  2. Explain the pattern. Use London forces in your answer.
    Compare after your attempt

    More electrons give stronger London forces. Stronger forces need more energy to overcome, so the boiling point is higher.

  3. Does the graph support your hypothesis? Explain.
    Compare after your attempt

    It supports a hypothesis that more electrons give a higher boiling point. Every noble gas with more electrons boils higher.

  4. Radon has 86 electrons. Use your graph to predict whether radon boils above or below xenon. Then compare with the value −61.7 °C.
    Compare after your attempt

    Above. Radon has more electrons than xenon, so the curve continues upward. The value −61.7 °C is higher than −108.1 °C.

  5. Explain why the noble gases are a good choice for a test of London forces.
    Compare after your attempt

    They are single atoms and are non-polar. They have London forces only, so no other force changes the result.

  6. Write a conclusion of two or three sentences. Answer the question and give your evidence.
    Compare after your attempt

    The boiling point of a noble gas rises with its number of electrons. Helium, with 2 electrons, boils at −268.9 °C. Xenon, with 54 electrons, boils at −108.1 °C.

4. Connect

  1. Fritz London explained these forces in 1930. Boiling points were measured long before that. Explain how the measurements and the explanation work together.
    Compare after your attempt

    The measurements are the evidence. The theory explains the pattern in the evidence. A theory is accepted when it explains what is measured.

  2. Liquid helium cools the magnets in hospital MRI machines. Use the table to explain why helium is chosen.
    Compare after your attempt

    Helium has the lowest boiling point in the table, −268.9 °C. So liquid helium is colder than any of the other liquids.